본문 바로가기
HOME> 논문 > 논문 검색상세

논문 상세정보

Performance characteristics of a MPCM slurry cooled unit designed for telecommunication equipment

Choi, Jong-Min    (Department of Mechanical Engineering, Hanbat National University   ); Jeon, Jong-Ug    (Department of Mechanical Engineering, Korea University   ); Kim, Yong-Chan    (Department of Mechanical Engineering, Korea University  );
  • 초록

    Optimum control of the PCB surface temperature is very important in achieving high performance and operational reliability of telecommunication equipment with high power density and thermal density. In this study, the performance of a liquid cooling unit with MPCM slurries(called as "MPCM cooled unit") was tested and analyzed. In addition, its performance was compared with that of an air cooled unit and a water cooled unit. The maximum surface temperature and the index of uniform temperature distribution(IUTD) were introduced to analyze cooling performance. The surface temperature in the unit rack of telecommunication equipment can be controlled properly by using an MPCM cooled unit instead of an air cooled unit. The maximum surface temperature and IUTD of the MPCM cooled unit at the inlet temperature of $19^{\circ}C$ were lower than those at inlet temperatures of $25^{\circ}C$ and $27^{\circ}C$ due to the increases of heat capacity and heat transfer rate. The heat capacity of the MPCM cooled unit increased significantly with the increase of mass flow rate due to high specific heat of MPCM particles with latent heat transfer rate. The cooling performance of the MPCM cooled unit was superior to that of the water cooled unit.


  • 주제어

    MPCM .   Liquid cooling .   Heat density .   Telecommunication equipment.  

  • 참고문헌 (19)

    1. P. Cinato, C Bianco, L. Licciardi, F. Pizzuti, M. Antonetti and M. Grossoni, An innovative approach to the environmental system design for TLC rooms in Telecom Italia, INTELEC, (1998) 770-776 
    2. C. C. Sullivan, Cooling data and dot-coms, Consulting- Specifying Engineering 29 (1) (2001) 28-36 
    3. G. Dumont, F. V. Roux and B. Righini, Watercooled electronics, Nuclear Instruments & Methods in Physics Research A 440 (2000) 213-223 
    4. H. Y. Zhang, D. Pinjala, T. N. Wong, K. C. Toh and Y. K. Joshi, Single-phase liquid cooled microchannel heat sink for electronic packages, Applied Thermal Engineering 25 (10) (2005) 1427-1487 
    5. J. S. Lock, E. Bertson and J. Boissevain, Air cooling of front-end electronics for silicon detectors in collider experiments, Nuclear Instruments and Methods in Physics Research A 345 (1994) 284-288 
    6. Y. Yamagishi, H. Takeuchi, A. T. Pyatenko and N. Kayukawa, Characteristics of MPCM slurry as a heat transfer fluid, AIChE 45 (1999) 696-707 
    7. H. Lee, Y. Jeong, J. Shin, J. Baek, M. Kang and K. Chun, Package embedded heat exchanger for stacked multi-chip module, Sensors and Actuators A. 114 (2004) 204-211 
    8. C. W. Leung, J. J. Kang and S. D. Robert, Horizontal simulated printed-circuit board assembly in fully-developed laminar-flow convection, Applied Energy 56 (1) (1997) 71-91 
    9. H. Hayama and M. Nakao, Air flow systems for telecommunications equipment rooms, INTELEC, (1989) 1-7 
    10. G. Hetsroni, A. Mosyak, Z. Segal and G. Ziskind, A uniform temperature heat sink for cooling of electronic devices, International Journal of Heat and Mass Transfer 45 (16) (2002) 3275-3286 
    11. R. J. McGlen, R. Jachuck and S. Lin, Integrated thermal management techniques for high power electronic devices, Applied Thermal Engineering 24 (2004) 1143-1156 
    12. K. E. Gill, Telecom HVAC cool connections (HVAC in telecommunication facilities), HVAC Engineering. 73 (1) (2001) 29-38 
    13. M. Choi and K. Cho, Liquid cooling for a multichip module using fluorinert liquid and paraffin slurry, International Journal of Heat and Mass Transfer 43 (2) (2000) 209-218 
    14. H. Inaba, New challenge in advanced thermal energy transportation using functionally thermal fluids, International Journal of Thermal Science 19 (2000) 991-1003 
    15. J. G. Lee, J. H. Kim, Y. C. Choi, S. H. Lee, Y. G. Kim, J. G. Choi, H. S. Han, W. M. Lee, H. S. Kim, Y. S. Shin, K. H. Kim, H. J. Lee and J. M. Choi, Development of high density thermal fluid and heat transportation technology, MOST Report M102KP- 010001-03K1601-02410 KOSEF, Seoul, Korea (2005) 
    16. J. L. Alvarado, C. Marsh, C. Sohn, G. Phetteplace and T. Newell, Thermal performance of microencapsulated phase material slurry in turbulent flow under constant heat flux, International Journal of Heat and Mass Transfer 50 (2007) 1938-1952 
    17. R. R. Schmidt and H. Shaukatullah, Computer and telecommunications equipment room cooling: A review of literature, IEEE Transactions on Components and Packaging Technologies 26 (1) (2003) 89-98 
    18. M. Nakao, H. Hayama and T. Uekusa, An efficient cooling system for telecommunication equipment rooms, INTELEC, (1988) 344-349 
    19. J. Jeon, Y. Kim, J. M. Choi, H. Kang and D. Cheon, Performance comparison of liquid-cooling with aircooling heat exchangers for telecommunication equipment, The 3rd Asian Conference on Refrigeration and Air-conditioning, Gyeongju, Korea. (2006) Paper No. 227 

 저자의 다른 논문

  • 최종민 (44)

    1. 2003 "다중 유로에서 과열도의 불균형에 따른 증발기의 성능 특성에 관한 연구" 설비공학논문집 = Korean journal of air-conditioning and refrigeration engineering 15 (12): 1043~1048    
    2. 2004 "일반화된 오리피스의 유량예측 상관식 및 유량선도" 설비공학논문집 = Korean journal of air-conditioning and refrigeration engineering 16 (10): 895~900    
    3. 2004 "A Generalized Correlation and Rating Charts for Mass Flow Rate through Capillary Tubes with Several Alternative Refrigerants" International journal of air-conditioning and refrigeration 12 (4): 192~197    
    4. 2005 "나선형 핀튜브 열교환기의 열전달 특성에 관한 실험적 연구" 설비공학논문집 = Korean journal of air-conditioning and refrigeration engineering 17 (6): 529~535    
    5. 2005 "열펌프의 정량적 특허기술 분석에 관한 연구" 설비공학논문집 = Korean journal of air-conditioning and refrigeration engineering 17 (9): 808~815    
    6. 2005 "R-410A 임계영역 운전조건에서 오리피스의 성능특성에 관한 연구" 설비공학논문집 = Korean journal of air-conditioning and refrigeration engineering 17 (12): 1106~1112    
    7. 2005 "압축식 열펌프의 제상${\cdot}$제어 특허기술 분석" 설비공학논문집 = Korean journal of air-conditioning and refrigeration engineering 17 (12): 1192~1203    
    8. 2005 "핀의 전도 열전달 및 과열도 변화에 따른 증발기 성능 특성에 관한 연구" 설비공학논문집 = Korean journal of air-conditioning and refrigeration engineering 17 (3): 216~222    
    9. 2006 "통신기지국용 하이브리드 냉방기의 성능특성 연구" 설비공학논문집 = Korean journal of air-conditioning and refrigeration engineering 18 (11): 874~880    
    10. 2006 "통신장비용 앰플리파이어 액체냉각장치 및 냉각유체 분배기의 최적설계 및 성능특성" 설비공학논문집 = Korean journal of air-conditioning and refrigeration engineering 18 (1): 24~30    
  • 전종욱 (4)

  • 김용찬 (104)

 활용도 분석

  • 상세보기

    amChart 영역
  • 원문보기

    amChart 영역

원문보기

무료다운로드
  • 원문이 없습니다.
유료다운로드

유료 다운로드의 경우 해당 사이트의 정책에 따라 신규 회원가입, 로그인, 유료 구매 등이 필요할 수 있습니다. 해당 사이트에서 발생하는 귀하의 모든 정보활동은 NDSL의 서비스 정책과 무관합니다.

원문복사신청을 하시면, 일부 해외 인쇄학술지의 경우 외국학술지지원센터(FRIC)에서
무료 원문복사 서비스를 제공합니다.

NDSL에서는 해당 원문을 복사서비스하고 있습니다. 위의 원문복사신청 또는 장바구니 담기를 통하여 원문복사서비스 이용이 가능합니다.

이 논문과 함께 이용한 콘텐츠
이 논문과 함께 출판된 논문 + 더보기