본문 바로가기
HOME> 논문 > 논문 검색상세

논문 상세정보

Journal of electrical engineering & technology v.7 no.3, 2012년, pp.312 - 319   SCIE
본 등재정보는 저널의 등재정보를 참고하여 보여주는 베타서비스로 정확한 논문의 등재여부는 등재기관에 확인하시기 바랍니다.

A Study on the Hot Spot Temperature in 154kV Power Transformers

Kweon, Dong-Jin    (Transmission & Distribution Laboratory, Korea Electric Power Research Institute   ); Koo, Kyo-Sun    (Transmission & Distribution Laboratory, Korea Electric Power Research Institute   ); Woo, Jung-Wook    (Transmission & Distribution Laboratory, Korea Electric Power Research Institute   ); Kwak, Joo-Sik    (Transmission & Distribution Laboratory, Korea Electric Power Research Institute  );
  • 초록

    The life of a power transformer is dependent on the life of the cellulose paper, which influenced by the hot spot temperature. Thus, the determination of the cellulose paper's life requires identifying the hot spot temperature of the transformer. Currently, however, the power transformer uses a heat run test is used in the factory test to measure top liquid temperature rise and average winding temperature rise, which is specified in its specification. The hot spot temperature is calculated by the winding resistance detected during the heat run test. This paper measures the hot spot temperature in the single-phase, 154kV, 15/20MVA power transformer by the optical fiber sensors and compares the value with the hot spot temperature calculated by the conventional heat run test in the factory test. To measure the hot spot temperature, ten optical fiber sensors were installed on both the high and low voltage winding; and the temperature distribution during the heat run test, three thermocouples were installed. The hot spot temperature shown in the heat run test was $92.6^{\circ}C$ on the low voltage winding. However, the hot spot temperature as measured by the optical fiber sensor appeared between turn 2 and turn 3 on the upper side of the low voltage winding, recording $105.9^{\circ}C$ . The hot spot temperature of the low voltage winding as measured by the optical fiber sensor was $13.3^{\circ}C$ higher than the hot spot temperature calculated by the heat run test. Therefore, the hot spot factor (H) in IEC 60076-2 appeared to be 2.0.


  • 주제어

    Power transformer .   Life .   Hot spot .   Temperature .   Optical fiber sensor.  

  • 참고문헌 (12)

    1. Susa, D. and Nordman, H., "A Simple Model for Calculating Transformer Hot-Spot Temperature," IEEE Transactions on Power Delivery, Vol. 24, pp.1257-1265, 2009. 
    2. G. Sliter, "Life Cycle Management Planning Source books(Volume 4: Large Power Transformers) Final Report," EPRI, March 2003. 
    3. IEEE C57.91, "IEEE Guide for loading mineral-oilimmersed transformers", 1995. 
    4. Bicen, Y., et. al., "An assessment on aging model of IEEE/IEC standards for natural and mineral oilimmersed transformer," IEEE International Conference on Dielectric Liquids, pp.1-4, 2011. 
    5. Jian Li, et. al., "Hot spot temperature models based on top-oil temperature for oil immersed transformers," IEEE Conference on Electrical Insulation and Dielectric Phenomena, pp.55-58, 2009. 
    6. Ruijin Liao, "A comparative study of thermal aging of transformer insulation paper impregnated in natural ester and in mineral oil," European Transactions on Electrical Power, 2009. 
    7. IEC 60076-7, "Loading guide for oil immersed power transformers", 2005. 
    8. JEC-2200, "Transformers", 1995. 
    9. Technical Standards of KEPCO (ES)-6120-0001, "154kV Power Transformers", 2009. 
    10. KS C IEC 60076-1, "Power Transformers - Part 1: General", 2002. 
    11. KS C IEC 60076-2, "Power Transformers - Part 2: Temperature rise", 2002. 
    12. IEC 60076-2, "Temperature rise for liquid-immersed transformers", 2011. 

 저자의 다른 논문

  • 권동진 (31)

    1. 1996 "超音波 信號 數의 移動平均에 의한 電力用 變壓器 豫防診" 電氣學會論文誌 = The transactions of the Korean Institute of Electrical Engineers 45 (3): 432~437    
    2. 1996 "논단 1-전력용 변압기 예방진단 기술" 電機工業 = KOEMA journal 7 (2): 28~38    
    3. 1997 "동축원통 전극내의 파티클에 의한 음향신호 분석" 照明·電氣設備學會誌 = Journal of the Korean institute of illuminating and electrical installation engineers 11 (6): 104~110    
    4. 1998 "$SF_6$ 가스 동축원통전극 내의 금속이물이 절연파괴에 미치는 영향" 照明·電氣設備學會論文誌 = Journal of the Korean Institute of Illuminating and Electrical Installation Engineers 12 (2): 85~90    
    5. 2000 "제어기 형태에 따른 HVDC 안정도 분석" 전기학회논문지. The transactions of the Korean Institute of Electrical Engineers. B, 전기기기 및 에너지변환시스템부문 49 (10): 665~674    
    6. 2001 "외부 코로나 노이즈를 제거한 내부 부분방전 측정기법" 照明·電氣設備學會論文誌 = Journal of the Korean Institute of Illuminating and Electrical Installation Engineers 15 (1): 44~50    
    7. 2001 "가스분석기법을 이용한 전력용 변압기 내부 이상진단을 위한 진단 알고리즘 및 전문가시스템 개발" 照明·電氣設備學會論文誌 = Journal of the Korean Institute of Illuminating and Electrical Installation Engineers 15 (5): 68~74    
    8. 2001 "변압기 부분방전 상시 감시기법에 관한 연구" 전기전자재료학회논문지 = Journal of the Korean institute of electronic material engineers 14 (12): 1032~1040    
    9. 2001 "온라인 변압기 부분방전 측정기법 적용" 전기학회논문지. The transactions of the Korean Institute of Electrical Engineers. C/ C, 전기물성·응용부문 50 (8): 394~400    
    10. 2001 "이산 웨이블렛 변환 기법을 이용한 변압기 열화신호의 특징추출에 관한 연구" 전기학회논문지. The transactions of the Korean Institute of Electrical Engineers. C/ C, 전기물성·응용부문 50 (3): 121~129    
  • 구교선 (9)

  • 우정욱 (20)

  • 곽주식 (11)

 활용도 분석

  • 상세보기

    amChart 영역
  • 원문보기

    amChart 영역

원문보기

무료다운로드
유료다운로드

유료 다운로드의 경우 해당 사이트의 정책에 따라 신규 회원가입, 로그인, 유료 구매 등이 필요할 수 있습니다. 해당 사이트에서 발생하는 귀하의 모든 정보활동은 NDSL의 서비스 정책과 무관합니다.

원문복사신청을 하시면, 일부 해외 인쇄학술지의 경우 외국학술지지원센터(FRIC)에서
무료 원문복사 서비스를 제공합니다.

NDSL에서는 해당 원문을 복사서비스하고 있습니다. 위의 원문복사신청 또는 장바구니 담기를 통하여 원문복사서비스 이용이 가능합니다.

이 논문과 함께 출판된 논문 + 더보기